Brackets for 360 ml Click-on dispensers – The 360 ml Click-on system uses a holding element that the bottle snaps onto, so the unit can be taken off and put back without tools. This category covers those click-on holders and their fixing parts. They are specified for new installations and ordered individually where the retaining element has worn or been damaged in service.
State the number of positions, the wall type and whether the holders replace existing ones on the same drill pattern. Where several products sit side by side, plan the spacing from the holder dimensions. Fixing details and dimensions are given on the product page for each item.
Brackets for 360 ml Click-on dispensers: procurement considerations
- Snap fitting: the bottle clicks onto the element and releases by hand, which makes the housekeeping round quicker than with a screwed holder
- Retention wear: the retaining element is the part that takes the load in daily use, so it is the item most often reordered as a spare
- System-specific: the holder is matched to the 360 ml Click-on bottle and does not fit the magnetic or cartridge formats
- Alignment: set the holders out on a common line so that the bottles read as a row rather than sitting at slightly different heights
Frequently asked questions about this category
Can the bottle be removed without a tool?
Yes. The click-on element is released by hand, which is the point of the system for daily top-ups.
Are these holders available as spare parts on their own?
Yes, they are listed individually so a single worn element can be replaced without changing the dispenser.
